You will be removing your exhaust outlet and replacing it with the FAE. Our Removal - Installation Kit includes the supplies needed to make this MUCH easier: Debond (adhesive remover to loosen the seal of the existing exhaust outlet), wooden wedges (to help with removal), and 3M 5200 marine adhesive (this is the industry standard).
The 3M 5200 Marine Adhesive comes in two versions.
Fast Cure - Cures in 48 hours. This is the industry standard.
Slow Cure - takes a week to cure. It is significantly stronger than the fast cure and exceeds the industry standard.
Otherwise they apply and clean up the same. On both, the boat must remain still and above 40 degrees Fahrenheit or 5 degrees Celsius while curing. You will also need to provide either acetone or mineral spirits for the clean-up. This 3M marine adhesive is in a cartridge so you will need a cartridge dispenser (caulk gun). You will also need masking tape and rags.
